CN

Dismantling

You can find important details on dismantling in the Technical Regulations and in our Check-In / Traffic Management which will be available to you at the latest four weeks before the event begins.

You may start with dismantling not before the end of the event, at the earliest on Friday, 15 June 2018 at 4:00 pm. Freight lifts in the halls and the gates to the ground-floor levels will not be open until 6:30 pm and there are no forklifts available.

Empties will not be available until 8:00 am on Saturday, 16 June 2018. Exception: priority delivery of empty packaging for exhibitors with little material which has to be ordered well in advance. Forklifts will not be available until 8:00 am and only if they were ordered well in advance.

Special dismantling permits (cash deposit for entry permit) only for passenger cars and vans up to   3,5 metric tons maximum gross weight. The numbers of these permits is limited. They can be obtained on the last two set-up days as well as on the first four exhibition days from Technical Organisation in hall 4.C by signing a declaration that 200 € will be invoided if the vehicle has not left the exhibition gournd by 6:00 pm.

Entry starts for vehicles up to 7.49 metric tons maximum gross weight from the assembly point for dsimantling vehicles on the Rebstock parking area. Entry to the exhibition grounds begins exclusively from this location...

FromSaturday16 June 201808:00 a.m.
untilTuesday19 June 2018

06:00 p.m.

Setting-Up and Dismantling Passes only entitle the holder to enter the exhibition premises during the assembly and dismantling days. They do not permit entry during the exhibition itself.

Passes for assembly and dismantling can be ordered free of charge in the exhibitor portal. If necessary,  additional passes for assembly and dismantling can be obtained at the Technical Service Centre in hall 4.C during the assembly phase.

© DECHEMA Ausstellungs-GmbHPrint page